Alpha Technologies APX Series Manual del operador descargar pdf (Pagina 39)

Photo 2.11.5.3.d

2. INSTALLATION

2.11.5.3 LA-E (230VAC Models) Photo 2.11.5.3.a, .b, .c, .d

Procedure:

The LA-E mounts on the back of the front panel and is secured by means of the

existing screw. This option must be hard-wired into the rack-mount unit by means of

quick-connect connectors.

1. Remove the wing-nut from the screw on the LA-E mounting bracket.

Position the LA-E as shown in Photo 2.10.5.d and secure using the same

screw.

2. Trim the wires supplied with the LA-E so the ends are flush with no copper

wire exposed. Carefully insert the flush end into the quick-splice connector

so the end is flush with the internal wire-stop. Fold this end of the connector

shut and crimp tight using pliers. Repeat this procedure for the other wire.

See Photo 2.11.5.3.a

3. Locate the BLUE wire from the AC power cord. Place this wire into the open

end of the quick-splice connector (connected to the BLUE wire on the

LA-E), fold, and crimp tight. Photos 2.11.5.3.a and .b.

4. Locate the BROWN wire from the AC power cord. Place this wire into the

open end of the quick-splice connector (connected to the BROWN wire on

the LA-E), fold, and crimp tight. Photos 2.11.5.3.a and .b.

2.11 Options,

continued

Brown Wire

(from AC Power Cord)

Blue Wire

(from AC Power Cord)

Quick-connect

Splice connectors

Blue or Brown Wire

(from AC Power Cord)

Blue or Brown Wire

(from LA-E)

Photo 2.11.5.3.cPhoto 2.11.5.3.a Photo 2.11.5.3.b

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 47 48

Sin comentarios

Alpha Technologies APX Series Manual del operador Pagina 39